1. The green indicator light is on, the two heating switches of the upper and lower forming and the heat sealing are respectively pulled to the "ON" position, the workbench is the first, the temperature controller controls the forming temperature, generally preset 90C° and 100C° respectively, the second thermostat is heat sealed, and the temperature of the thermostat is preset for forming and heat sealing, as appropriate.
2. Put down the briquetting on the primer roller, the temperature of the forming heating plate is in place, and then open the host, the plastic PVC is formed first, and the forming bubble eye is consistent with the hole position of the heat sealing mold, pay attention to the heat sealing mold holder with the handle to put down the heat sealing mold and press the aluminum foil, and the aluminum foil will drive to the blanking. Observe whether the plastic (referring to the PVC surface of the machine plate has been formed) is offset left and right. If there is a bias, the starting roller seat should be adjusted to adjust the starting direction.
3. If the aluminum foil is offset left and right, the handwheel of the knuckle roller seat can be adjusted down. If the front and rear deviation is adjustable, the box can be moved.
4. After the heat sealing and blanking are normal, open the feeder ram moderately, so that the appropriate amount of drugs (tablet capsules, sugar coating) enters the feeding room, if there is a small amount of missing grains, it can be manually filled, and the primary precautions when filling the granules: the roller pressure roll rolls and the hook breaks the aluminum foil, and the forming bubble hole is over the side of the pressure roller, there is a lack of grains, do not reluctantly make up for it, and the hole is not filled, when the drug is brought in, it will seriously affect the synchronization.
5. Due to the increase in the weight of the drug, the tensile force of the aluminum foil and the gradual change of the temperature of the machine, the molding and heat sealing may be out of sync, ahead or lagging, first check whether the plastic PVC and aluminum foil have a shade, and then the machine can be adjusted by the fine-tuning mechanism. The fine-tuning mechanism is adjusted in front of and backward in the mold, because of its adjustment distance or the front and back adjustment of the box. Therefore, it should be placed in a neutral position before starting, so that it can be moved forward and backward, and it can also be adjusted by moving the front box.
6. The heat sealing quality of plastic aluminum foil (uniform bonding, firm and flat) is proved by temperature or pressure, and the flatness of the anilox board.
7. Punching deviation, cutting with layout offset, stopping the machine to move the manual adjustment box, can adjust the mold shift.
